Benutzeranleitung / Produktwartung C21RJAN des Produzenten Samsung
Zur Seite of 28
Installation and Operating Instructions Ceramic Glass Hob C 2 1 R J A N s e r i e s T o avoid the risk of accidents or damage to the hob, read all instructions before installing or using the appliance. Keep this manual for future reference. C21RJAN_XSA-00144A_EN.
C21RJAN_XSA-00144A_EN.indd 2 2008-10-07 5:01:11.
1 EN Contents Using This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Electrical safety . . . . . . . . . . . . .
2 EN Using This Manual Please take the time to read this owner ’ s manual, paying particular attention to the safety information contained in the following section, before using your appliance. Keep this manual for future reference. If transferring ownership of the appliance, please remember to pass the manual on to the new owner .
3 EN Safety The safety aspects of this appliance comply with accepted technical standards and the German Appliance Safety Law . However, as manufacturers we also believe it is our responsibility to familiarise you with the following safety instructions.
4 EN Safety (continued) Safety during use • This appliance is to be used only for normal cooking and frying in the home. It is not designed for commercial or industrial use. • Never use the hob for heating the room. • T ake care when plugging electrical appliances into mains sockets near the hob.
5 EN Installing the Hob Important : Be sure the new appliance is installed and grounded only by qualied personnel. Please observe this instruction. The warranty will not cover any damage that may occur as a result of improper installation. T echnical data is provided at the end of this manual.
6 EN Installing the Hob (Continued) Connecting to the outlet Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob.
7 EN Parts and Features Cooking zones and control panel Single cooking zone 1950W Single cooking zone 1300 W Control panel Heat setting selectors Indicators for heat settings and residual heat “Lock” control sensor “On/Off” control sensor T imer indicator and control sensors C21RJAN_XSA-00144A_EN.
8 EN Parts and Features (Continued) Components 1 Ceramic Glass Hob 2 Installation Brackets 3 Screws C21RJAN_XSA-00144A_EN.indd 8 2008-10-07 5:01:15.
9 EN Parts and Features (Continued) The key features of your appliance • Ceramic glass cooking surface: The appliance has a ceramic glass cooking surface and four rapid - response cooking zones. The hob’ s powerful radiant heater elements signicantly shorten the amount of time required for the zones to heat up.
10 EN Parts and Features (Continued) Safety shutoff If one of the cooking zones is not switched off or the heat setting is not adjusted after an extended period of time, that particular cooking zone will automatically switch itself off.
1 1 EN Before Y ou Begin Initial cleaning Wipe the ceramic glass surface with a damp cloth and ceramic hob glass cleaner . Important: Do not use caustic or abrasive cleaners. The surface could be damaged. Hob Use Using suitable cookware Better pans produce better results.
12 EN Hob Use (Continued) • Always position pots and pans before switching on the cooking zone. • Dirty cooking zones and pan bases increase power consumption. • When possible, position the lids rmly on the pots and pans to cover completely .
13 EN Hob Use (Continued) Switching the appliance on T ouch the “Lock ” sensor for approximately 3 seconds. The appliance is switched on using the “On / Off ” control sensor . T ouch the “On / Off ” sensor . The digital displays will show .
14 EN Hob Use (Continued) Switching the appliance off T o completely switch off the appliance, use the “On / Of f ” control sensor . T ouch the “On / Off ” sensor .
15 EN Hob Use (Continued) Using the child safety lock Y ou can use the child safety lock to safeguard against unintentionally turning on a cooking zone and activating the cooking surface. The lock control sensor can be used only when the power is on. Switching the child safety lock on 1.
16 EN Hob Use (Continued) Switching the child safety lock off 1. T ouch the control sensor for approximately 3 seconds. An acoustic signal will sound as conrmation.
17 EN Hob Use (Continued) T imer There are two ways to use the timer: Using the timer as a safety shutoff If a specic time is set for a cooking zone, the cooking zone will shut itself off once this period of time has elapsed. This function can be used for multiple cooking zones simultaneously .
18 EN Hob Use (Continued) T o display the time remaining for any of the cooking zones, use the timer’s control sensor . The corresponding control indicator will begin to blink slowly . The settings are reset using the or timer setting control sensors.
19 EN Cleaning and Care Hob Important: Cleaning agents must not come into contact with a heated ceramic glass surface: All cleaning agents must be removed with adequate amounts of clean water after cleaning because they can have a caustic effect when the surface becomes hot.
20 EN Cleaning and Care (Continued) Pr oblem Dirt 1. Remove burnt-on sugar, melted plastic, aluminium foil or other materials with a glass scraper immediately and while still hot. Important : There is a risk of burning yourself when the glass scraper is used on a hot cooking zone: 2.
21 EN W arranty and Service F AQs and troubleshooting A fault may result from a minor error that you can correct yourself with the help of the following instructions. Do not attempt any further repairs if the following instructions do not help in each specic case.
22 EN W arranty and Service (Continued) What does it mean when the burner does not glow red? • The selected temperature of the cooking zone is maintained by a sensor that cycles the zone on and off, so the surface cooking area will not always glow red.
23 EN T echnical Data Appliance dimensions Width 288 mm Depth 505 mm Height 50 mm Worktop cut - out dimensions Width 273 mm Depth 490 mm Corner radius 3 mm Cooking rings Position Diameter Power Front 148 mm 1,300 W Rear 183 mm 1,950 W Connection voltage 240 V ~ 50 Hz Maximum connected load power 3.
24 EN Note C21RJAN_XSA-00144A_EN.indd 24 2008-10-07 5:01:21.
25 EN Note C21RJAN_XSA-00144A_EN.indd 25 2008-10-07 5:01:22.
Code No.:DG68- 00144A-01 C21RJAN_XSA-00144A_EN.indd 26 2008-10-07 5:01:22.
Ein wichtiger Punkt beim Kauf des Geräts Samsung C21RJAN (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Samsung C21RJAN noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Samsung C21RJAN - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Samsung C21RJAN reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Samsung C21RJAN erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Samsung C21RJAN besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Samsung C21RJAN verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Samsung C21RJAN. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Samsung C21RJAN gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
