Benutzeranleitung / Produktwartung TANNIN 625.348261 des Produzenten Kenmore
Zur Seite of 32
OWNER'S MANUAL MODEL NO. 625.348261 Caution: Read and Follow All Safety Rules and Operating Instructions Before First Use of This Product. If you have questions when installing, operating or main- taining your filter, and when setting the timer, call this toll-free number.
I_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_iii_ _ WARRANTY _i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_ W A R R A N T Y SEARS RESIDENTIAL WATER FILTER FULL ON.
TABLE OF CONTENTS T A B O F C O N T E N SECTION 1 A. B. C. D. WATER FILTER START UP PAGE NO. Safety Guides ........................................ 1-1 Check List of All Step-By-Step Guides to Install ......... 1-2 Program the Timer ..................
SECTION1 WATER FILTER START UP A. SAFETY GUIDES S C T N • Read all steps, guides and rules carefully before installing and using your new water filter. Follow all steps exactly to correctly install. Failure to follow them could cause personal injury or property damage.
SECTION1 WATER FILTER START UP B. CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL Refer to the Installation Manual, part number 7146611, for step-by-step guides. To be sure you have done all the steps to install the filter, read the following list. Page numbers referred to are in the Installation Manual.
SECTION1 WATER FILTER START UP C. PROGRAM THE TIMER I I;l[_lJ;l=lP;I g_, _Mtt F'ittratMn display / / A UP button DOWN button SELECT button RECHARGE button When the transformer is plugged into the electri- cal outlet a model code is displayed for a few sec- onds followed by a test number (example: J1.
SECTION1 WATER FILTER START UP C. PROGRAM THE TIMER 2. SET DAYS TO RECHARGE 3. SET RECHARGE TIME This setting is the number of days the filter will go between recharges. The default setting is 2 days, with a maximum setting of 99. The filter is factory set to begin recharge at 12:00 AM.
SECTION1 WATER FILTER START UP D. SANITIZING THE WATER FILTER Care is taken at the factory to keep your water fil- ter clean and sanitary. Materials used to make the filter will not infect or contaminate your water suppl)5 and will not cause bacteria to form or grow.
I SECTION 2 HOW YOUR WATER FILTER WORKS A. FACEPLATE TIMER FEATURES I ;l [_lJ ;] =l[_] S C T RECHARGE NOW For times you expect to use more water than usual, use the RECHARGE NOW feature. Press the RECHARGE button and hold in for three seconds. "RECHARGE NOW" begins to flash in the display and a re- charge starts right away.
I SECTION 2 HOW YOUR WATER FILTER WORKS A. FACEPLATE TIMER FEATURES The default settings for fill (6:00 minutes), brine draw (80 minutes), backwash (12 minutes) and fast rinse (8 minutes) cycles of regeneration are factory set for maximum performance of the filter.
I SECTION 2 HOW YOUR WATER FILTER WORKS B. FILTERED WATER, SERVICE AND REGENERATION IMPORTANT: Sears water filters are sometimes installed alone in the water system, but most often other water treating equipment is needed. Always be sure to have your water tested by a qualified testing labo- ratory.
I SECTION 2 HOW YOUR WATER FILTER WORKS B. FILTERED WATER, SERVICE AND REGENERATION BRINE RINSE: After a premeasured amount of brine is used, the brine valve closes. Water flow continues as during brining, except for the brine draw. Tannin particles and brine are flushed from the resin tank to the drain.
I SECTION 3 CARE OF YOUR FILTER A. CHECKING THE SALT STORAGE LEVEL AND REFILLING S C T N Brine (salt dissolved in water) is needed for each and every re- generation. The water for mak- ing brine is metered into the salt storage tank by the filter. How- ever, you must keep salt in the tank.
I SECTION 3 CARE OF YOUR FILTER C. CLEANING THE FILTER RESIN BED To keep the tannin resin bed clean and working efficientlN do the following at least once each month. thoroughly stirred, pour the solution directly into the brinewell (see key no. 25, page 6-2).
SECTION 3 CARE OF YOUR FILTER E. KEEP THE FILTER FROM FREEZING If the filter is installed where it could freeze (sum- mer cabin, lake home, etc.) you must drain all wa- ter from it to stop possible damage caused by freezing. To drain the filter- Ii Close the shutoff valve on the house main wa- ter pipe, near the water meter or pressure tank.
I SECTION 3 CARE OF YOUR FILTER F. BEFORE YOU CALL FOR SERVICE... HELPFUL HINTS CHECKLIST PROBLEM CAUSE CORRECTION NO FILTERED WATER No salt, or salt bridged, in storage tank. FILTER RECHARGES, BUT FILTERED WATER SOMETIMES CONTAINS TANNINS Plumbing bypass valve(s) in "bypass" 3osition.
I_ SECTION 4 _ OTHER THINGS TO KNOW Ill [ _'J'llJ-'| =!li_] S C T N A. DIMENSIONS / SPECIFICATIONS BYPASS VALVES SINGLE-PLASTIC PULL STEM J OUTWARD / FOR / Push /" _ Inward / " For _f" Bypass / / o=Iet_ Va I'o_ _ 3-VALVE .
I_ SECTION 4 _ OTHER THINGS TO KNOW A. DIMENSIONS / SPECIFICATIONS Pretreatment Needed For Higher Amounts Supply Water Limits Listed MAX, WATER HARDENSS: .............................. 10 gpg Water Softener Water Softener and/or MAX, CLEAR WATER IRON: .
I_ SECTION 5 _ __ SERVICE TECH. INFORMATION A. WIRING SCHEMATIC S C T N 24VAC TRANSFORMER I r -m POSITION SWITCH IMPORTANT: KEEP THIS MANUAL WITH YOUR WATER FILTER. IF REPAIRS ARE NEEDED, THE SER- VICE TECHNICIAN MUST HAVE THE INFORMATION ON THE FOLLOWING PAGES.
I_ SECTION 5 SERVICE TECH. INFORMATION B. TROUBLESHOOTING ALWAYS MAKE THESE INITIAL CHECKS FIRST 1. Does the time display show the correct time of day? ...If display is blank, check power source to the filter. ...If time is flashing, power was off for over two days.
I_ SECTION 5 SERVICE TECH. INFORMATION B. TROUBLESHOOTING MANUAL ADVANCE DIAGNOSTICS Use the following procedures to advance the filter valve through the regeneration cycles to check op- eration. Remove the top cover to observe cam and switch operation during valve rotation.
I_ SECTION 5 SERVICE TECH. INFORMATION C. ROTARY VALVE SERVICE IMPORTANT: Before working on the valve, turn off the water supply and disconnect from electrical power• To relieve pressure: •.. THREE VALVE BYPASS: Close the inlet and open a filtered water faucet• Then close the outlet valve and open the bypass valve.
I_ SECTION 5 _ __ SERVICE TECH. INFORMATION D. WATER FLOW THROUGH THE FILTER VALVE SERVICE CYCLE VALVE OUTLET (FILTERED WATER) INLET (UNFILTERED WATER) TOP DISTRIBUTOR POSITION SWITCH RESIN __ TANK RESIN _BED s 4_ _ 4_,S # kX BOTTOM DISTRIBUTOR Unfiltered water enters the vane inlet port.
I_ SECTION 5 _ __ SERVICE TECH. INFORMATION D. WATER FLOW THROUGH THE FILTER VALVE BRINING AND BRINE RINSE CYCLES VALVE OUTLET (BYPASS UNFILTERED WATER) ROTOR & DISC VENTURI . NOZZLE DRAIN ; INLET : (UNFILTERED WATER) BRINE FROM SALT STORAGE TANK After fill, timer/switch action allows the motor to turn the rotor and disc into BRINING position.
I_ SECTION 5 _ __ SERVICE TECH. INFORMATION D. WATER FLOW THROUGH THE FILTER VALVE FAST RINSE CYCLE ROTOR & DISC POSITION SWITCH OUTLET DRAIN INLET TOP DISTRIBUTOR ## "'-'_ BOTTOM D.
I_ SECTION 6 REPAIR PARTS Kenmore MODEL NO. 625.348261 S C T N 22 26 ----19 20 27 f 28 ._,_ 29 30 31 21 39 ,/ I 32 / 33 37 34 35 36 6-1 Problems, Questions? Call 1-800-426-9345 Kenmore Water Line.
I_ SECTION 6 REPAIR PARTS Kenmore MODEL NO. 625.348261 KEY PART KEY PART DESCRIPTION NO, NO. NO, NO, 1 7275907 Transformer 22 7180437 2 7259927 Wire Harness 23 0500283 3 7285677 Rep'l Faceplate Timer 24 7082150 4 0900300 Screw, #4 x 1/4" (2 req'd.
I_ SECTION 6 REPAIR PARTS Kenmore MODEL NO. 625.348261 17 18 41 40 3O 47 46 / X 43 42 44 19 2O 21 6-3 Problems, Questions? Call 1-800-426-9345 Kenmore Water Line.
SECTION 6 REPAIR PARTS Kenmore MODEL NO. 625.348261 KEY PART DESCRIPTION NO, NO. 1 7070412 Screw, #4 - 24 x 1 - 1/8 in. 2 7117816 Spacer 3 7030713 Switch 4 7077472 Expansion Pin 5 7074123 Screw, #10 14 x 2 in. (5 req'd) 6 7085263 Valve Cover 7 7082087 Wave Washer 8 7199232 Rotor & Disc 9 7199729 Cap 10 7170262 O-ring Seal, 1-1/8 in.
SECTION 6 REPAIR PARTS NOTES 6-5 Problems, Questions? Call 1-800-426-9345 Kenmore Water Line.
SECTION 6 REPAIR PARTS NOTES 6-6 Problems, Questions? Call 1-800-426-9345 Kenmore Water Line.
Your Home For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, acc.
Ein wichtiger Punkt beim Kauf des Geräts Kenmore TANNIN 625.348261 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Kenmore TANNIN 625.348261 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Kenmore TANNIN 625.348261 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Kenmore TANNIN 625.348261 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Kenmore TANNIN 625.348261 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Kenmore TANNIN 625.348261 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Kenmore TANNIN 625.348261 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Kenmore TANNIN 625.348261. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Kenmore TANNIN 625.348261 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
